Application: General purpose recessed downlight housing for medium to high ceilings for
residential and light commercial applications. A variety of trims, compatible styles and
finishes are available to achieve the proper décor and illumination.
Housing: Pre-wired .037� aluminum housing adjusts up to 1 1/2� ceiling thickness. Trim is
secured with torsion wing springs/standard coil springs.
Mounting: Housing suitable for new construction installations only, supplied with (2) 24"
adjustable hanger bars with 90 degrees repositioning ability. Hanger bars equipped with
nail-less install 3/4" serrated barbed studs and with captive nails, for faster and easier
secure mounting in wood joists. Set-screws lock into position and prevent shifting after
installation. Earthquake structural cable compatible for drop panel ceiling or any other
mounting that requires direct support from structural ceilings.
Ballast: Electronic Class P 60Hz Ballast with Inherent thermal protection. For Double Twin
Tube (DTT) or Triple Twin Tube Lamps (TTT). Sound A rated. Micro-Processor controlled.
Min. starting temperature -10ºC. Accessible from above or below the ceiling. Contact
factory for detailed technical information on ballast specifications. Note: For dimming
applications must use compatible dimmer swtich. Consult specific ballast manufacturer for
up-to-date compatibility list.
Socket: Thermo-plastic socket UL Listed rated for high temperature and provides nickel
plated contacts. Either accepts 2-Pin lamps for use with magnetic ballast or 4-Pin lamps
with electronic ballast selection. Vertically adjustable galvanized steel plate enables lamp
repositioning to optimize performance.
Junction Box:16 gauge pre-wired galvanized steel Junction Box, 32 cubic-inch for a
maximum of (8) #12 AWG wires. Furnished with (7) 3/4" and (4) Romex knock-outs. Strain
clamps to install or remove covers for easy access and ground wire. Equipped with safety
standard fitting for flex-conduit.
Airflow: Airtight option is designed to restrict air flow from room into plenums in compliance
to the WSEC - Washington State Energy Code, (Less than 2.0 CFM -Cubic Feet per
Minute). Complies to Title24 air flow requirements (Air-tight).