Application: General purpose recessed downlight housing for low to medium height ceilings
for residential and light commercial applications. A variety of trims, compatible styles and
finishes are available to achieve the proper décor and illumination.
Housing: Pre-wired housing adjusts up to 1 1/4”ceiling thickness. This housing has torsion
remodeling clips for secure installation. Integral thermal protector to guard against
improper lamping and installation. Housing provides an adjustable socket plate wich allows
for use of different lamp types. Trim is secured with torsion wing springs/standard coil
springs. Designed to be installed in existing sheet rock ceilings via ceiling cut out (above
ceiling access is not required).
Mounting:Housing suitable for existing or new construction installations, supplied with high
tension remodeling clips, designed to secure the housing to an existing sheet rock ceiling
for fast and easy installation.
Transformer: Class H insulated magnetic transformer installed adjacent to Junction Box,
bottom and top accessible. Thermally protected rated for 90º C
Socket: 2-pin porcelain socket with aluminum heat sink plate. Lamp clips to trim to ensure
proper and consistent positioning.
Junction Box: 16 gauge pre-wired galvanized steel Junction Box, 32 cubic-inch for a
maximum of (8) #12 AWG wires. Furnished with 3/4", 1" and Romex knock-outs. Strain
clamps to install or remove covers for easy access and ground wire. Equipped with safety
standard fitting for flex-conduit.
Insulation Contact: Non IC rated housing must be kept 3” from insulation.
Airflow: Airtight option is designed to restrict air flow from room into plenums in compliance
to the WSEC - Washington State Energy Code, (Less than 2.0 CFM -Cubic Feet per
Minute). Complies to Title24 air flow requirements (Air-tight).
