Application: General purpose recessed downlight housing for low to medium height ceilings
for residential and light commercial applications. A variety of trims, compatible styles and
finishes are available to achieve the proper décor and illumination.
Mounting: Housing suitable for new construction installations only, supplied with (2) 24"
adjustable hanger bars with 90 degrees repositioning ability. Hanger bars equipped with
nail-less install 3/4" serrated barbed studs and with captive nails, for faster and easier
secure mounting in wood joists. Set-screws lock into position and prevent shifting after
installation. Earthquake structural cable compatible for drop panel ceiling or any other
mounting that requires direct support from structural ceilings.
Transformer: High quality insulated transformer installed adjacent to Junction Box, bottom
and top accessible. Thermally protected rated for 90º C. Available in magnetic or "noisefree"
electronic.
Socket: 2-pin porcelain socket with aluminum heat sink plate. Lamp clips to trim to ensure
proper and consistent positioning.
Junction Box:16 gauge pre-wired galvanized steel Junction Box, 32 cubic-inch for a
maximum of (8) #12 AWG wires. Furnished with (7) 3/4" and (4) Romex knock-outs. Strain
clamps to install or remove covers for easy access and ground wire. Equipped with safety
standard fitting for flex-conduit.
Insulation Contact: IC rated housing rated for direct contact with low to medium density
loosefill blown and rolled insulation. For use with high density loosefill blown insulation,
reduce rated lamp wattage accordingly (roughly %15-%20).
Airflow: Airtight option is designed to restrict air flow from room into plenums in compliance
to the WSEC - Washington State Energy Code, (Less than 2.0 CFM -Cubic Feet per
Minute). Complies to Title24 air flow requirements (Air-tight).
